The control interface with a difference......it has a memory! FlowGo can be used as a traditional control interface to control 2D and 3D models direct from the computer. It can also be used on its own as a stand-alone computer. When used with Go Software (also available from Newton), a control program can be downloaded into its memory. This allows FlowGo to run totally independently whilst disconnected from the computer. You could therefore use models that are a distance away, or perhaps ones which are wall-mounted.
Technical Information:
-
4mm sockets for all Inputs and Outputs
-
Features 6 outputs - for 6V bulbs, LEDs, buzzers etc
-
2 Motor Outputs to run motors forwards, backwards and at variable speeds
-
4 Inputs for any switch
-
2 Analogue Inputs - 3.5mm jack socket for temperature and light sensors
-
Can be connected to either the USB port of the serial port of the computer
Pack contains FlowGo, mains power supply and battery snap connector, USB and serial leads, and manual.
